Chance Epoxiglas™ 4.5-Foot Slide Hammer Elbow Puller Tool (grippers sold separately) C4031851

These tools facilitate removing elbow connectors from bushings of transformers and other apparatus. Elbows that have been installed for a long period of time sometimes are difficult to remove because silicone grease on the interface of the elbow and bushing dries out and hardens. A special integral hook on the tool heat fits through the rubber eye of an elbow or the metal hook of a bushing cap. Used in this manner, the hook adds extra control and pulling power to the grippers. Design Features The lightweight tool employs a simple, slide-hammer mechanism to easily disengage and assist in replacing elbows. The tool and grippers (sold separately) help the operator control the elbow and stiff underground cable lead. For a sure, balanced grip the 5-pound slide hammer is plastisol coated and flared at both ends. Also for secure handling, both front and rear handgrip areas of the pole are coated with Griptread, a grit-filled rubber-base paint. Operation To pull an elbow connector: Insert hook through eye on elbow. Close down grippers on elbow by rotating pole. Support tool with one hand on front grip behind handguard and other hand on slide hammer. Slam hammer from front to rear anvil. Resulting impact should release elbow with sufficient momentum to withdraw it from the bushing without extended arcing. To replace an elbow connector: Follow the same procedures for pulling except use slide hammer impact against front anvil to help seat the elbow.
Features:

Lightweight tool uses slide-hammer mechanism to easily disengage and replace elbows

Tool and grippers (sold separately) help operator to control elbow and stiff underground cable lead

For sure, balanced grip, 5-lb. slide hammer is plastisol coated and flared at both ends

For secure handling, both front and rear handgrip areas of pole are coated with Griptread

Available in three lengths, tools are made of 1-1/4"-diameter orange Epoxiglas® pole

6' & 8' foot units meet OSHA requirements. 4-1/2' unit, labeled "For Rubber Glove Use Only", has 5"-long insulation length

Specifications:

EU RoHS Indicator: No

Storage Bag Included: No (P643-6 bag must be ordered separately.)

Style: Impact Elbow Puller

Type: Underground Tools

UPC: 096359019565

Dimensions: 66 in x 4.38 in x 4.38 in

Weight: 12.0 lb (5.4 kg)
Made in the USA